EAFC 12V Portable Car Jump Starter & Power Bank

EAFC 12V Portable Car Jump Starter & Power Bank

Never get stranded again. The EAFC Portable Jump Starter delivers powerful, reliable emergency starting power in a compact, pocket-friendly design — ready whenever and wherever you need it. Whether you're on a remote road trip or stuck in a parking lot, this device gets you back on the road in minutes, no second car required.

Engineered for both everyday drivers and road-trip enthusiasts, this unit doubles as a high-capacity power bank, keeping your devices charged while ensuring your vehicle is always ready to go. With a built-in multi-mode LED flashlight and SOS distress signal, it's the ultimate all-in-one roadside companion.

Key Features

• ⚡ Peak Current: 1200A (petrol up to 4L / diesel up to 2L) or 2000A (petrol up to 6L / diesel up to 4L)
• 🔋 Battery Capacity: 12,000–18,000 mAh — charges phones, tablets & more via USB 5V/2A
• 💡 Built-in LED Flashlight with steady, strobe, and SOS emergency modes
• 🌡️ Wide Operating Range: -20°C to 60°C — reliable in all seasons
• 🔌 12V Jump Start Output with smart clamps and reverse polarity protection
• ✅ Certified: FCC, CE, ROHS, CCC — built to international safety standards
• 🧳 Compact & Portable: Fits in your glove box, go-bag, or trunk

Specifications

Peak Current: 1200A / 2000A
Starting Current: 600A / 1000A
Jump Start Output: 12V
USB Output: 5V / 2A
Operating Temperature: -20°C to 60°C
Compatibility: Petrol engines up to 6L & diesel engines up to 4L

Night Emergency & Rescue Lighting

1. Built-in high-intensity LED lighting system.
2. Double-click to activate red & blue flash mode; double-click again to exit.
3. Long-press the middle button for 3 seconds to activate flashlight; press again for burst mode.
4. After turning on the flashlight, press the switch again to activate distress/SOS flash mode.

🚗 How to Jump Start Your Car

1. First Charge — Fully charge for 4+ hours before first use
2. Connect — Red clamp to battery (+) terminal, black clamp to clean metal ground
3. Start — Insert connector, turn ignition (max 3 seconds per attempt)
4. Wait — If unsuccessful, wait 60+ seconds before next attempt
5. Disconnect — Remove clamps within 30 seconds after successful start

Important Usage Notes

• On first use, activate flashlight discharge mode (hold power button 3s+), then charge for 4+ hours before starting your vehicle
• Recommended to start with 3 bars / 60%+ charge for best results
• Do not reverse polarity or short-circuit the clamps
• Wait at least 60 seconds between start attempts
• Remove clamps within 30 seconds of a successful start
• Store at room temperature; recharge every 3 months if not in regular use

In the Box

1× Jump Starter Unit
1× Battery Clamp Cable
1× USB Charging Cable
1× Instruction Manual